Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Dania Beach, FL
Gate installation in Dania Beach usually starts with the post, not the gate. The 33004 housing stock runs heavily to 1950s through 1970s concrete-block and stucco bungalows, so the masonry piers and side walls a new gate hangs from are often original, out of plumb, and softened by decades of salt air. We plan every Dania Beach install around re-plumbing and re-anchoring those supports before a single hinge gets bolted on, then we size the operator, keypad, and hardware for wind-driven rain and the corrosion cycle that comes from living between the Atlantic and the Intracoastal. Call us at (855) 362-1433 for a free measure and a written price.
Why Dania Beach Homes Are Different
Dania Beach sits in the salt-spray belt, and that single fact reshapes how gates fail and how they should be installed. Hinges, rollers, opener circuit boards, and low-voltage keypad wiring corrode and seize far faster here than even a few miles inland. A hinge bolt that would last a decade in Davie can bind and snap within a couple of seasons a block off the Intracoastal. We see seized rollers, seized hinges, and corroded keypad terminals as routine Dania Beach findings, not unusual ones. Tropical-storm and hurricane wind-load cycles add another layer: a gate that is just heavy enough inland becomes a sail here, and hardware that was never rated for repeated gusts loosens and wallows out its own mounts. The narrow, low-slung lots near the water and the dense mix of older single-family homes and small marinas mean most gates are tight-fit driveway or side-yard gates on small footprints, not the long runs and wide setbacks you find in HOA subdivisions west of I-95. That changes how we measure, how we build, and which operator we recommend.
Styles & brands we work with
Our Main Dania Beach Services
Most Dania Beach callers reach us for one of two reasons: a gate that has stopped opening or closing the way it should, or an automated gate where the operator has failed. Both are covered below, and each has its own dedicated Dania Beach page.
Gate Repair in Dania Beach
Gate repair in Dania Beach is rarely a simple swap. The salt air that eats hinge bolts and roller bearings also means the surrounding posts and side walls have often drifted, so we re-plumb and re-anchor the structure instead of bolting new hardware onto a failing one. Whether you have a narrow manual side-yard gate on an aging stucco wall or a small automated barrier at a marina entrance, the goal is the same: get the gate swinging or sliding true again and keep it that way through the next storm season. See the full breakdown on our Gate Repair in Dania Beach page.
Electric Gate Repair in Dania Beach
Electric gate repair in Dania Beach has to account for what the coastal air does to circuit boards, limit switches, and low-voltage wiring. Our techs diagnose across nine operator brands, so when a LiftMaster or Mighty Mule opener near the water starts faulting or a keypad quits after a heavy rain, we find the actual failed component instead of guessing and replacing parts on hope. One call covers the gate and the operator, which spares you from coordinating a fencing company with an electrician. Read more on our Electric Gate Repair in Dania Beach page.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Dania Beach
Gate installation in Dania Beach has to start with the existing structure, because most of the 33004 homes we visit were built between the 1950s and 1970s and the original masonry is rarely square anymore. Salt air has been working on those posts and side walls for decades, so a new gate that is simply hung on old, drifting anchors will sag within a year and bind by the second. We rebuild the Piers and re-anchor the hardware first, then install the gate and operator as one system rated for marine exposure and repeated wind-load cycles. Our full Gate Installation service covers everything from a simple manual side-yard gate to a fully automated driveway barrier.
Automatic Gate Installation
Signs you need it
You are done getting out of the car in the rain to open a gate, or your property needs controlled entry that a manual gate cannot provide.
What it costs in Dania Beach
Automatic gate installation in Dania Beach typically runs from $4,200 to $14,000 depending on gate size, operator type, and power access.
How we do it
We measure the opening and footprint, rebuild or add mounting piers as needed, install the gate leaf and operator, then run and seal the power and low-voltage wiring for coastal exposure.
Driveway Gate Installation
Signs you need it
The existing driveway gate sags, binds, or no longer closes fully, or the opening needs a wider automated barrier than the old one.
What it costs in Dania Beach
A new driveway gate installation in Dania Beach typically runs from $3,800 to $12,500 depending on width, material, and automation.
How we do it
We survey the driveway width and setbacks, set or re-plumb the posts, hang the gate on marine-grade hinges or rollers, and finish with the operator if it is being automated.
Sliding Gate Installation
Signs you need it
The driveway or side access is too tight for a swinging gate to clear, or you want a single-panel barrier that tracks along the wall line instead of arcing into the yard.
What it costs in Dania Beach
Sliding gate installation in Dania Beach typically runs from $4,500 to $13,800, with cantilever or track systems at the upper end.
How we do it
We build or repair the track base or cantilever posts, set the gate panel square to the run, and install rollers and stops rated for the salt and wind load.
What Gate Installation Costs in Dania Beach
| Item | Typical range in Dania Beach |
|---|---|
| Manual gate installation | $2,900 – $8,000 |
| Driveway gate installation | $3,800 – $12,500 |
| Automatic gate installation | $4,200 – $14,000 |
Does Hacienda handle the concrete work for a new gate in Dania Beach?
We handle the post setting, re-plumbing, and anchoring that a new gate needs, including rebuilding soft or cracked masonry piers on older Dania Beach homes. We do not pour large slabs or footings beyond what the gate requires.
Can you install a salt-air-rated opener near the Intracoastal?
Yes. We size the operator and enclosure for marine exposure, and we seal all low-voltage connections against wind-driven rain. We stock weather-rated hardware as a normal part of Dania Beach jobs, not a special order.
Brands We Service in Dania Beach
We work on your brand. Our techs carry diagnostic and repair capability for LiftMaster, FAAC, Elite, and Mighty Mule operators, with common control boards, limit switches, and receiver parts stocked for Dania Beach callouts. That means fewer return trips and less waiting on a part to ship. See the full rundown on our brands.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Dania Beach, FL
| Service | Typical range in Dania Beach |
|---|---|
| Manual gate installation | $2,900 – $8,000 |
| Driveway gate installation | $3,800 – $12,500 |
| Automatic gate installation | $4,200 – $14,000 |
| Sliding gate installation | $4,500 – $13,800 |
| Gate opener installation | $1,800 – $5,200 |
| Electric gate opener repair | $280 – $750 |
| Gate sensor or keypad repair | $180 – $450 |
| Hinge or roller replacement | $150 – $420 |
| Full automation upgrade | $2,400 – $6,800 |
In Dania Beach, the two things that push a gate job toward the upper end are coastal corrosion damage and out-of-square masonry on older homes. When posts have to be rebuilt and re-anchored, the labor hours go up. Every price is quoted and agreed before any work starts, so you know the number before we begin.
Neighborhoods We Serve in Dania Beach
We cover the full 33004 ZIP and the tight coastal lots that define Dania Beach. Our service area includes the older single-family corridors near the water, the small multifamily blocks, and the marina-side properties where gate clearances run narrow and salt exposure runs high.
- Downtown Dania Beach
- Dania Beach Marina area
- Waterfront neighborhoods along the Intracoastal
- Hollywood-Dania line
- Lakeside Dania Beach
Most Dania Beach callouts happen same week, with repair trips often same day depending on how close to the Intracoastal you are.
Service Area – Cities Near Dania Beach
Our crews run service calls from Dania Beach into the surrounding Broward cities, including West Hollywood, FL, Melrose Park, FL, Hallandale Beach, FL, and Pembroke Park, FL. If you are a few minutes outside the 33004 line, call and we will confirm the next available slot.
Serving Dania Beach, FL — Our Local Coverage Area
We’re based in the Dania Beach area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Dania Beach
For a gate that is stuck closed or stuck open, we aim for same-day response in the 33004 area, with most calls scheduled same week. Marina and Intracoastal properties get priority when the gate is the only access to a home or dock.
Most automatic driveway gates in Dania Beach require a permit, especially when power is being run to a new operator. We can tell you what the job needs and whether your HOA or marina association has additional setback or appearance rules.
We serve the entire 33004 ZIP, from the older single-family blocks to the marina and multifamily properties. The salt-air conditions are worse near the water, but the whole of Dania Beach is close enough to the coast that we treat corrosion resistance as standard.
If your gate has started to bind, sag, or refuse to open, call (855) 362-1433 for a free estimate. We will quote the price before any work begins, and you will deal with a gate specialist from the first call.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Dania Beach Customers Say
"Gate works properly now and the price was fair. The one thing is that it took two visits, because the operator model we have is old and the part had to be ordered. They didn't charge for the second trip."
— Ruben Guzman"Repair is holding. He was quite a bit later than the window I was given, and the office didn't call me about it, I had to call them. The work itself was done well once he got here."
— Eduardo Delgado"Photo eye was misaligned so the gate refused to close after dark. Ten minute fix. He also cleaned the lens and pointed out that the sprinkler head was spraying it every morning, which is why it kept happening."
— Alicia Jackson